Common Problems to Note Before Breaking & Drilling Tools Hire
Date : 05 December 2019
It generally looks simple when someone else is drilling a hole. They swiftly choose the correct drill bit, quickly connect it to the drill, turn it on and then finally drill through to form a hole. Then you give it a try and find that reality is a lot different than what you observed. Here are the most frequently reported drilling problems and how you can avoid them before you opt for breaking and drilling tools hire.
1) When the Drill Bit Breaks:
This can happen to anyone. You are drilling through a metal piece and suddenly the drill bit breaks.
Why This Happens and How to Avoid This?
- Flutes are usually clogged with chips: You should use jobber drills that have wider flutes and you may consider opting for polished flutes. Also, withdraw dill at intervals to clear any kind of chip out. In case, the chips aren’t broken, consider going for heavier feeds or chip breakers design.
- Drill outer corner is worn out: Check the coolant and your speed. Insufficient or wrong coolant can lead to excessive run out because the drill might enter the metal.
- Work might not be held in a secure manner leading it to slip: You must clamp the drill down, use adequate equipment for holding it tight so that your work is done in a still manner.
- If an improper point is used: Correct it for swift application.
- A twist drill is dull: replace or re-sharpen it.
- If you are using cheap jobber drill: opt for the best breaking and drilling tools hire.
2) When Your Drill Bit Slips
- Try utilizing a drill bit that has three flats on a shaft for a better grip.
3) When the Chips Are Not Breaking Up
For you, it might be way too frustrating! Chips that do not break in a proper manner can become stringy and long and then wrap themselves around tools, which means you may have to stop your work so that you can detangle them on a frequent basis.
What Is the Exact Cause? How Can You Stop This?
- When the feed is insufficient: Try to increase the feed.
- Imperfect style of the jobber drill or point utilized: Try to adjust.
4) When the Point Angle Tends to Damage
What Exactly Happened? How Can You Repair This?
- Using hard object suppose a metal hammer for hitting the drill in the socket can create this - You should avoid hitting into the socket with a drill, try using soft lead for the purpose, for instance, plastic hammer,
- When you drop or mishandle the jobber drill: Try to be utmost careful.
5) When You Drill A Big Hole
Though you used the correct sized drill but still the hole seems oversized.
What Exactly Happened? What Can You Do?
- The drill point is off the centre - replace or repoint to get accuracy.
- Your spindle of the machine is not very rigid- try to adjust.
- Your job piece is loose or it is vibrating - learn to tightly secure your work.
- Brushing can help repair the bigger hole.
For all your breaking & drilling tools hire, contact Eros Tools Hire, the best in the industry offering tool hire services.